GE Ultrasonic USM Go Operator's Manual page 57

2.4.2b Specifying the Probe Frequency (
In the ACQUIRE menu, activate the RECEIVER submenu using the joystick (
1.
2. Use the joystick (
3. To change the specified frequency, move the joystick (
Low Pass, 4, 5, 10, 13 MHz - Choose the frequency that matches the frequency of your probe.
•
BROADBAND - Select this option to use the built-in broadband filter.
•
4. After completing your selection, move the joystick up or down (
USM Go Operator's Manual
RECEIVER-FREQUENCY)
) to select the function titled FREQUENCY.
).
) or press the function toggle. The following options are available:
) to navigate away from this function.
Chapter 2. Instrument Setup
39