Table of Contents
Advertisement
Chapter 5. Data Recorder Files
5.2
Configuring the Data Recorder File
After entering a name for the data recorder file, the following parameters must be specified:
TOP - the coordinates of the first cell in the file, using a row number and an column letter (e.g. 1A).
•
BOTTOM - the coordinates of the last cell in the file, using a row number and an column letter (e.g. 10B).
•
ADV DIRECTION - specifies the direction (DOWN or RIGHT) in which the DR advances after each thickness reading is recorded.
•
Use the usual joystick methods to select each of the above functions and program the desired values.
5.3
Creating the Data Recorder File
1.
After naming and configuring the DR file, use the joystick (
2.
Press the center of the joystick (
IMPORTANT: After the DR file is created, the TOP and BOTTOM parameters cannot be changed. In fact, these functions are replaced on the
menu with listings of the NUM OF COLS and NUM OF ROWS, respectively.
130
) to create and activate a DR file that uses your previous selections.
) to select the function titled CREATE.
USM Go Operator's Manual
Advertisement
Table of Contents
