Accessing The Setup Mode Menu - GE Ultrasonic USM Go Operator's Manual

Chapter 1. General Information

1.4.2 Accessing the Setup Mode Menu

To access the Setup Mode menu, refer to the right side of Figure 4 on page 10 while completing the following steps:
1.
Press and hold the center of the joystick (
2.
Move the joystick left or right (
parameters available in the highlighted menu.
3.
Move the joystick as required (
4.
Press the center of the joystick (
the joystick ( ) as a fine adjustment or by pressing either end of the function toggle (
of the joystick ( ) again to deactivate the highlighted parameter.
Note: Step 4 above applies to the setting of all parameters, except for specifying the actions associated with the function toggle keys. For
instructions on configuring these keys, see "Defining Function Toggle Actions" on page 35.
12
) to toggle between Acquire Mode and Setup Mode.
) until the desired menu is highlighted on the menu bar. The function bar automatically shows the
) to highlight the desired parameter.
) to activate the highlighted parameter. The parameter value can now be changed either by moving
) as a coarse adjustment. Press the center
USM Go Operator's Manual