The Rail-Adjustment Bracket And The Release Tab - IBM SAN Volume Controller Hardware Maintenance Manual

1. Remove the M6 screw
Figure 48. The rail-adjustment bracket and the release tab on the rear rail-locking carrier
2. Starting from the rear, press the release tab
rail-adjustment bracket
secures the rear of the slide rail to the rear mounting flange.
3. Repeat step 2 to remove the front bracket and then remove the support rail from the rack.
4. Repeat steps 1 through 3 for the other support rail.
Removing the support rails for the SAN Volume Controller 2145-8G4
This topic describes how to remove the SAN Volume Controller 2145-8G4 support rails.
Perform the following steps to remove the SAN Volume Controller 2145-8G4 support rails:
1. Loosen and remove the captive screw
shown in Figure 49 on page 57, to release the slide rail
from the right rear mounting flange and release the other slide rail in the same way.
56
IBM SAN Volume Controller Hardware Maintenance Guide
1
from the front and rear brackets.
3
2
toward the center of the rack until it snaps into place. Lift the tab that
3
and latch strike
backwards, away from the rail. Push the
1
from the left rear mounting flange, as
2
. Loosen and remove the captive screw