IBM 2145-CF8 Hardware Installation Manual
IBM 2145-CF8 Hardware Installation Manual

IBM 2145-CF8 Hardware Installation Manual

System storage san volume controller errata

Advertisement

IBM System Storage SAN Volume Controller
Model 2145-CF8 Hardware
Installation Guide - Errata
Version 5.1.0
February 4, 2010
GC52-1356-01 Errata

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 2145-CF8 and is the answer not in the manual?

Questions and answers

Summary of Contents for IBM 2145-CF8

  • Page 1 IBM System Storage SAN Volume Controller Model 2145-CF8 Hardware Installation Guide - Errata Version 5.1.0 February 4, 2010 GC52-1356-01 Errata...
  • Page 2 2 SAN Volume Controller Model 2145-CF8 Hardware Installation Guide - Errata February 4, 2010...
  • Page 3: Table Of Contents

    Chapter 2. Installing the SAN Volume Controller 2145-CF8 Hardware ..........7 Installing the cable-management arm for the SAN Volume Controller 2145-CF8......7 Connecting the SAN Volume Controller 2145-CF8 to the SAN and to the Ethernet network ....9 © Copyright IBM Corp. 2009, 2010...
  • Page 4 4 SAN Volume Controller Model 2145-CF8 Hardware Installation Guide - Errata February 4, 2010...
  • Page 5: Introduction

    Volume Controller. Who should use this guide This errata should be used by anyone using the IBM System Storage SAN Volume Controller Model 2145-CF8 Hardware Installation Guide. You should review the errata contained within this guide and note the details with respect to the copy of the Model 2145-CF8 Hardware Installation Guide supplied with your SAN Volume Controller.
  • Page 6 6 SAN Volume Controller Model 2145-CF8 Hardware Installation Guide - Errata February 4, 2010...
  • Page 7: Chapter 2. Installing The San Volume Controller 2145-Cf8 Hardware

    4,5 and 6, the opposite to the previous instruction. Note that the angle between the two parts at assembly is important. Then insert the bracket into the rail after pulling the blue pin, steps 7 and 8. © Copyright IBM Corp. 2009, 2010...
  • Page 8 8 SAN Volume Controller Model 2145-CF8 Hardware Installation Guide - Errata February 4, 2010...
  • Page 9: Connecting The San Volume Controller 2145-Cf8 To The San And To The Ethernet Network

    The diagram and text labelling was incorrect, replace the first two instructions. Page 34. To connect the SAN Volume Controller 2145-CF8 to the SAN and to the Ethernet network, perform the following steps: 1. Connect an Ethernet cable to Ethernet port 1, as shown by 9 in the figure below. If required, connect the second Ethernet cable to Ethernet port 2 (8).
  • Page 10 10 SAN Volume Controller Model 2145-CF8 Hardware Installation Guide - Errata February 4, 2010...

Table of Contents