D-Link xStack DGS-3420 Series Reference Manual page 628

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
When the MAC-based access control function is enabled for a port, and the port is a MAC-based
access control guest VLAN member, the port(s) will be removed from the original VLAN(s) member
ports, and added to MAC-based access control guest VLAN member ports. Before the authentication
process starts, the user is able to forward traffic under the guest VLAN. After the authentication
process, the user will be able to access the assigned VLAN.
If the port authorize mode is port based mode, when the port has been moved to the authorized VLAN,
the subsequent users will not be authenticated again. They will operate in the current authorized VLAN.
If the port authorize mode is host based mode, then each user will be authorized individually and be
capable of getting its own assigned VLAN.
Format
config mac_based_access_control ports [<portlist> | all] {state [enable | disable] | aging_time
[infinite | <min 1-1440>] | block_time <sec 0-300> | max_users [<value 1-4000> | no_limit]}(1)
Parameters
<portlist> - Specify a range of ports to configure the MAC-based access control settings
all - Specify to select all the ports.
state - Specify whether the MAC-based access control function is enabled or disabled.
enable - Specify to enable the MAC-based access control function.
disable - Specify to disable the MAC-based access control function.
aging_time - Specify a time period during which an authenticated host will be kept in the
authenticated state. When the aging time is timed-out, the host will be moved back to
unauthenticated state.
infinite - Specify an unlimited aging time.
<min 1-1440> - Specify the age-out time, in minutes, between 1 and 1440.
block_time - Specify the blocking time, in seconds, between 0 and 300.
<second 0-300> - Specify the blocking time. The blocking time value must be between 0 and
300 seconds.
max_users - Specify the number of maximum users. The default value is 128 users.
<value 1-4000> - Specify the maximum number of users between 1 and 4000.
no_limit - Specify an unlimited number of users.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the port state for ports 1 to 8:
DGS-3420-28SC:admin# config mac_based_access_control ports 1-8 state enable
Command: config mac_based_access_control ports 1-8 state enable
Success.
DGS-3420-28SC:admin#
623