D-Link xStack DGS-3420 Series Reference Manual page 743

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
time_interval also need to be configured.
threshold - The upper threshold at which the specified storm control will turn on.
This is the number of broadcast/multicast/unknown unicast packets per second received by the
switch that will trigger the storm traffic control measure. It must be an unsigned integer.
<value 0-255000> - Specify the value between 0 and 255000.
broadcast_threshold - Specifies the upper threshold, at which point the specified storm control is
triggered. The value is the number of broadcast packets per second received by the switch that
will trigger the storm traffic control measure. The threshold is expressed as PPS (packets per
second) and must be an unsigned integer.
<value 0-255000> - Enter the broadcast threshold value used here. This value must be between
0 and 255000.
multicast_threshold - Specifies the upper threshold, at which point the specified storm control is
triggered. The value is the number of multicast packets per second received by the switch that will
trigger the storm traffic control measure. The threshold is expressed as PPS (packets per second)
and must be an unsigned integer.
<value 0-255000> - Enter the multicast threshold value used here. This value must be between 0
and 255000.
unicast_threshold - Specifies the upper threshold, at which point the specified storm control is
triggered. The value is the number of unicast packets per second received by the switch that will
trigger the storm traffic control measure. The threshold is expressed as PPS (packets per second)
and must be an unsigned integer.
<value 0-255000> - Enter the unicast threshold value used here. This value must be between 0
and 255000.
countdown - The timer for shutdown mode. When a port enters a shutdown RX state, and if this
times out, the port will shut down the port forever. The default is 0 minutes.
<min 0> - Zero is the disable forever state.
<min 3-30> - Enter a value between 5 and 30 minutes.
disable – Specifies that when the action is shutdown and the countdown is disabled, when the
Switch detects a storm, it will shutdown the port directly.
time_interval - The sampling interval of received packet counts. This parameter is meaningless for
dropping packets is selected as action.
<value 5-600> - Specify the value between 5 and 600.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure traffic control and state:
DGS-3420-28SC:admin#config traffic control 1-10 broadcast enable action shutdown
threshold 640 time_interval 10
Command: config traffic control 1-10 broadcast enable action shutdown threshold 640
time_interval 10
Success.
DGS-3420-28SC:admin#
738