D-Link xStack DGS-3420 Series Reference Manual page 669

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Note: If no parameter is specified, the system will display all currently configured MLD
snooping forwarding entries.
Restrictions
None.
Example
To display all MLD snooping forwarding entries located on the switch:
DGS-3420-28SC:admin#show mld_snooping forwarding
Command: show mld_snooping forwarding
VLAN Name : default
Source IP : 2001::1
Multicast Group: FF1E::1
Port Member : 2,7
VLAN Name : default
Source IP : 2001::1
Multicast Group: FF1E::2
Port Member : 5
Total Entries: 2
DGS-3420-28SC:admin#
58-19 clear mld_snooping data_driven_group
Description
This command is used to clear the MLD snooping group learned by data driven.
Format
clear mld_snooping data_driven_group [all | [vlan_name <vlan_name 32> | vlanid <vlanid_list>]
[<ipv6addr> | all]]
Parameters
all - Specifies to clear all the entries learned by the data driven feature.
vlan_name - Specifies the VLAN name used.
<vlan_name 32> - Enter the VLAN name used here.
vlanid - Specifies that VLAN ID list used.
<vlanid_list> - Enter the VLAN ID list used here.
<ipv6addr> - Enter the IPv6 address of the data driven group to be cleared here.
all - Specifies that all the IPv6 addresses will be cleared.
664