D-Link xStack DGS-3420 Series Reference Manual page 173

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
ipaddress - (Optional) The IP address and netmask of the IP interface to be created.
<network_address> - Specify the address and mask information using the traditional format
(for example, 10.1.2.3/255.0.0.0 or in CIDR format, 10.1.2.3/8).
vlan - (Optional) The name of the VLAN corresponding to the IP interface.
<vlan_name 32> - Specify the VLAN name. The maximum length is 32 characters.
state - Enable or disable the IP interface.
enable - Enable the IP interface.
disable - Disable the IP interface.
proxy_arp - (Optional) Enable or disable the proxy ARP. This is for the IPv4 function. The default
is disabled.
enable - Enable the proxy ARP.
disable - Disable the proxy ARP.
local - (Optional) This setting controls whether the system provides the proxy reply for the ARP
packets destined for IP addresses located in the same interface as the received interface.
When proxy ARP is enabled for an interface, the system will do the proxy reply for the ARP
packets destined for IP addresses located on a different interface. For ARP packets destined
for IP address located on the same interface, the system will check this setting to determine
whether to reply. The default is disabled.
enable - Enable the local proxy ARP function.
disable - Disable the local proxy ARP function.
bootp - Allows the selection of the BOOTP protocol for the assignment of an IP address to the
switch's System IP interface.
dhcp - Allows the selection of the DHCP protocol for the assignment of an IP address to the
switch's System.
ipv6 - The following are IPv6-related parameters.
ipv6address - The IPv6 address and subnet prefix of the IPV6 address to be created.
prefix_name - Specifies the IPv6 prefix name used here.
<string 1-12> - Enter the IPv6 prefix name used here. This name can be up to 12
characters long.
<ipv6networkaddr> - The IPv6 address and subnet prefix of the IPv6 address to be
created.
state - Enable or disable the IPv6 state of the IP interface.
enable - Enable the IPv6 state of the IP interface.
disable - Disable the IPv6 state of the IP interface.
ip_mtu - Specifies the IP Layer MTU value used.
<value 512-1712> - Enter the IP Layer MTU value used here. The value must be between
512 and 1712.
ipv4 state - The state of the IPv4 interface.
enable - Enable the IPv4 state of the IP interface.
disable - Disable the IPv4 state of the IP interface.
dhcpv6_client - Specifies the DHCPv6 client state of the interface.
enable - Specifies that the DHCPv6 client state of the interface will be enabled.
disable - Specifies that the DHCPv6 client state of the interface will be disabled.
ip_directed_broadcast - Specifies to enabled or disabled the IP directed-broadcast state of a
specified interface.
enable - Specifies to enabled the IP directed-broadcast state of a specified interface.
disable - Specifies to disabled the IP directed-broadcast state of a specified interface.
dhcp_option12 - Specifies to clear the DHCP Option 12 hostname setting. If host name is
empty, system name will be used to encode Option 12.
hostname - Specifies the DHCP Option 12 hostname used.
<hostname 63> - Enter the DHCP Option 12 hostname used here. This name can be up
to 63 characters long.
clear_hostname - Specifies to clear the DHCP Option 12 hostname setting.
state - Specifies the state of this function.
enable - Specifies that the clear DHCP Option 12 hostname setting will be enabled.
168