D-Link xStack DGS-3420 Series Reference Manual page 587
Layer 2 managed stackable gigabit switch cli
Hide thumbs
Also See for xStack DGS-3420 Series:
- Reference manual (499 pages) ,
- Hardware installation manual (53 pages) ,
- How to set up (2 pages)
Table of Contents
Advertisement
xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Command: show lldp
LLDP System Information
Chassis ID Subtype
Chassis ID
System Name
System Description
System Capabilities
LLDP Configurations
LLDP Status
LLDP Forward Status
Message TX Interval
Message TX Hold Multiplier: 4
ReInit Delay
TX Delay
Notification Interval
DGS-3420-28SC:admin#
51-5
config lldp forward_message
Description
This command is used to configure LLDP forwarding messages. When LLDP is disabled and LLDP
forward message is enabled, the received LLDPDU packet will be forwarded. The default state is
disabled.
Format
config lldp forward_message [enable | disable]
Parameters
enable - Enable LLDP forwarding messages.
disable - Disable LLDP forwarding messages.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable LLDP forwarding messages:
DGS-3420-28SC:admin#config lldp forward_message enable
Command: config lldp forward_message enable
: MAC Address
: 00-11-22-33-44-55
:
: Gigabit Ethernet Switch
: Repeater, Bridge
: Disabled
: Disabled
: 30
: 2
: 2
: 5
582
Advertisement
Table of Contents
