Chapter 14 Smtp Commands - D-Link xStack DGS-3420 Series Reference Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Chapter 14
enable smtp
disable smtp
config smtp {server <ipaddr> | server_port <port_number 1-65535> | self_mail_addr <mail_addr
254> | [add mail_receiver <mail_addr 254> | delete mail_receiver <index 1-8>]}
show smtp
smtp send_testmsg
14-1 enable smtp
Description
This command is used to enable SMTP status. If SMTP is enabled, the Switch sends e-mail with the
urgent events including system start, port link change, SNMP authentication failure, config or log save
by user, config reset by user, and TFTP update FW status to the designated e-mail address when any
problem occurs on the Switch.
Format
enable smtp
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To enable SMTP status:
DGS-3420-28SC:admin# enable smtp
Command: enable smtp
Success.
DGS-3420-28SC:admin#
14-2 disable smtp
Description
This command is used to disable SMTP status.
SMTP Commands
872