Chapter 36 Filter Commands - D-Link xStack DGS-3420 Series Reference Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Chapter 36
config filter extensive_netbios [<portlist> | all] state [enable | disable]
show filter extensive_netbios
config filter netbios [<portlist> | all] state [enable | disable]
show filter netbios
36-1 config filter extensive_netbios
Description
This command is used to configure the switch to deny NetBIOS packets over 802.3 frames on the
network. Enabling the filterNetBIOS packets over 802.3 frames will create one access profile and one
access rule per port automatically. Filter commands in this file will share the same access profile.
Format
config filter extensive_netbios [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Specify the port or range of ports to configure.
all - Specify to configure all ports.
state - Specify the status of the filter to block the NetBIOS packets over 802.3 frames.
enable - Enable the filter to block the NetBIOS packets over 802.3 frames.
disable - Disable the filter to block the NetBIOS packets over 802.3 frames.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the extensive NetBIOS filter state on ports 1 to 10:
DGS-3420-28SC:admin#config filter extensive_netbios 1-10 state enable
Command: config filter extensive_netbios 1-10 state enable
Success.
DGS-3420-28SC:admin#
Filter Commands
427