D-Link xStack DGS-3420 Series Reference Manual page 247
Layer 2 managed stackable gigabit switch cli
Hide thumbs
Also See for xStack DGS-3420 Series:
- Reference manual (499 pages) ,
- Hardware installation manual (53 pages) ,
- How to set up (2 pages)
Table of Contents
Advertisement
xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
19-1
debug address_binding
Description
This command is used to start the IMPB debug when the IMPB module receives an ARP/IP packet or
a DHCP packet.
Format
debug address_binding [event | dhcp | all] state [enable | disable]
Parameters
event - To print out the debug messages when IMPB module receives ARP/IP packets.
dhcp - To print out the debug messages when the IMPB module receives the DHCP packets.
all - Print out all debug messages.
state - Specifies the state of the address binding debugging option.
enable - Specifies that the address binding debugging option will be enabled.
disable - Specifies that the address binding debugging option will be disabled.
Restrictions
Only Administrator level users can issue this command.
Example
To print out all debug IMPB messages:
DGS-3420-28SC:admin# debug address_binding all state enable
Command: debug address_binding all state enable
Success.
DGS-3420-28SC:admin#
19-2
no debug address_binding
Description
This command is used to stop the IMPB debug starting when the IMPB module receives an ARP/IP
packet or a DHCP packet.
Format
no debug address_binding
Parameters
None.
242
Advertisement
Table of Contents
