D-Link xStack DGS-3420 Series Reference Manual page 781

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the priority1 value of the boundary clock as 127:
DGS-3420-28SC:admin# config ptp boundary priority1 127
Command: config ptp boundary priority1 127
Success.
DGS-3420-28SC:admin#
71-7 config ptp ports
Description
This command is used to configure the per port state of the PTP clock.
PTP port active state should meet the following three conditions:
Chapter 1 The global PTP state is enabled.
Chapter 2 The port PTP state is enabled.
Chapter 3 The port is not blocked, if the stp state is enabled.
Format
config ptp ports [<portlist> | all] state [enable | disable]
Parameters
ports - Specifies the list of port used for this configuration.
<portlist> - Enter the list of port used for this configuration here.
all - Specifies that all the ports will be used for this configuration.
state - Specifies the port state of the PTP clock function.
enable - Specifies that the port state of the PTP clock function will be enabled.
disable - Specifies that the port state of the PTP clock function will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable PTP on ports 1:1-1:4:
776