D-Link xStack DGS-3420 Series Reference Manual page 248

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Restrictions
Only Administrator level users can issue this command.
Example
To stop IMPB debug: starting when the IMPB module receives an ARP/IP or DHCP packet:
DGS-3420-28SC:admin# no debug address_binding
Command: no debug address_binding
Success.
DGS-3420-28SC:admin#
19-3 debug error_log
Description
Use this command to dump, clear or upload the software error log to a TFTP server.
Format
debug error_log [dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
Parameters
dump - Display the debug message of the debug log.
clear - Clear the debug log.
upload_toTFTP - Upload the debug log to a TFTP server specified by IP address.
<ipaddr> - Specifies the IPv4 address of the TFTP server.
<path_filename 64> - The pathname specifies the DOS pathname on the TFTP server. It can be
a relative pathname or an absolute pathname. This value can be up to 64 characters long.
Restrictions
Only Administrator level users can issue this command.
Example
To dump the error log:
DGS-3420-28SC:admin# debug error_log dump
Command: debug error_log dump
**************************************************************************
# debug log: 1
# firmware version: 1.00.011
243