D-Link xStack DGS-3420 Series Reference Manual page 1095

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
JWAC
Event description: When a client host authenticated successful.
Log Message: JWAC authenticated user (Username: <string>, IP:
<ipaddr>, MAC: <macaddr>, Port: <[unitID:]portNum>)
Parameters description:
string: Username
ipaddr: IP address
macaddr: MAC address
unitID: The unit ID
portNum : The port number
Event description: When a client host fails to authenticate.
Log Message: JWAC unauthenticated user (User Name: <string>, IP:
<ipaddr>, MAC: <macaddr>, Port: <[unitID:]portNum>)
Parameters description:
string: User name
ipaddr: IP address
macaddr: MAC address
unitID: The unit ID
portNum : The port number
Event description: This log will be triggered when the number of
authorized users reaches the maximum user limit on the whole
device.
Log Message: JWAC enters stop learning state.
Event description: This log will be triggered when the number of
authorized users is below the maximum user limit on the whole device
in a time interval (5 min).
Log Message: JWAC recovered from stop learning state.
LBD
Event Description: Loop back is detected under port-based mode.
Log Message:
Port < [unitID:] portNum> LBD loop occurred. Port blocked.
Parameters Description:
portNum: The port number.
Event Description: Port recovered from LBD blocked state under port-
based mode.
Log Message:
Port < [unitID:] portNum>LBD port recovered. Loop detection restarted
Parameters Description:
portNum: The port number.
Event Description: Loop back is detected under VLAN-based mode.
Log Message:
Port < [unitID:] portNum> VID <vlanID> LBD loop occurred. Packet
discard begun
Parameters Description:
portNum: The port number.
vlanID: the VLAN ID number.
Event Description: Port recovered from LBD blocked state under
VLAN-based mode.
Informational
Warning
Warning
Warning
Critical
Informational
Critical
Informational
1090