D-Link xStack DGS-3420 Series Reference Manual page 147

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
DGS-3420-28SC:admin#
auto_assign ip source_ip 10.0.0.1 dscp 25 destination_ip 10.90.90.90 port_group id
1 permit
Command: config egress_access_profile profile_id 2 add access_id auto_assign ip
source_ip 10.0.0.1 dscp 25 destination_ip 10.90.90.90 port_group id 1 permit
Success.
DGS-3420-28SC:admin#
To configure a vlan-base egress access rule that when the packet go out switch which match the
specified source MAC field, it will be dropped:
DGS-3420-28SC:admin#
ethernet source_mac 11-22-33-44-55-66 vlan_based vlan_id 1 deny
Command: config egress_access_profile profile_id 2 add access_id 1 ethernet
source_mac 11-22-33-44-55-66 vlan_based vlan_id 1 deny
Success.
DGS-3420-28SC:admin#
6-4 show egress_access_profile
Description
This command is used to display current egress access list table.
Format
show egress_access_profile {[profile_id <value 1-4> | profile_name <name 1-32>]}
Parameters
profile_id - (Optional) Specifies the index of the egress access list profile.
<value 1-4> - Enter the profile ID here. This value must be between 1 and 4.
profile_name - (Optional) Specifies the name of the profile. The maximum length is 32 characters.
<name 1-32> - Enter the profile name here. This name can be up to 32 characters long.
If no parameter is specified, will show the all egress access profile.
Restrictions
None.
Example
To display current egress access list table:
DGS-3420-28SC:admin# show egress_access_profile
Command: show access_profile
config egress_access_profile profile_id 2 add access_id
config egress_access_profile profile_id 2 add access_id 1
142