D-Link xStack DGS-3420 Series Reference Manual page 985

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
enable broadcast_ping_reply
disable broadcast_ping_reply
show broadcast_ping_reply
config tftp source_ipif [<ipif_name 12> {<ipaddr> | <ipv6addr>} | none]
show tftp source_ipif
29-1 download
Description
This command is used to download a new firmware or a switch configuration file.
Format
download [firmware_fromTFTP [<ipaddr> | <ipv6addr> | <domain_name 255>] src_file
<path_filename 64> {[unit <unit_id> | all]} {dest_file <pathname>} {boot_up} | cfg_fromTFTP
[<ipaddr> | <ipv6addr> | <domain_name 255>] src_file <path_filename 64> {[unit <unit_id> | all]}
{[increment | dest_file <pathname>]}]
Parameters
firmware_fromTFTP - Download and install new firmware on the switch from a TFTP server.
<ipaddr> - Specify the IP address of the TFTP server.
<ipv6addr> - Specify the IPv6 address of the TFTP server.
<domain_name 255> - Specifies the domain name of the TFTP server. This name can be up
to 255 characters long.
src_file - Specify the path name and file name of the TFTP server. It can be a relative path name
or an absolute path name. If path name is not specified, it refers to the TFTP server path. The
maximum length is 64 characters.
<path_filename 64> - Specify the path name and file name of the TFTP server. It can be a
relative path name or an absolute path name. If path name is not specified, it refers to the
TFTP server path. The maximum length is 64 characters.
unit - Specifies which unit on the stacking system. If it is not specified, it refers to the master unit.
<unit_id> - Enter the unit ID used here.
all - Specifies that all the units in the stacking system will be used.
dest_file - (Optional) Specify an absolute path name on the device file system. If path name is
not specified, it overwrites the bootup image on the Switch.
<pathname> - Specify an absolute path name on the device file system.
boot_up - (Optional) Specify as boot up file.
cfg_fromTFTP - Download and install new configuration file on the switch from a TFTP server.
<ipaddr> - Specify the IP address of the TFTP server.
<ipv6addr> - Specify the IPv6 address of the TFTP server.
<domain_name 255> - Specifies the domain name of the TFTP server. This name can be up
to 255 characters long.
src_file - Specify the path name and file name of the FTP server. It can be a relative path name
or an absolute path name. If path name is not specified, it refers to the TFTP server path. The
maximum length is 64 characters.
<path_filename 64> - Specify the path name and file name of the FTP server. It can be a
relative path name or an absolute path name. If path name is not specified, it refers to the
TFTP server path. The maximum length is 64 characters.
unit - Specifies which unit on the stacking system. If it is not specified, it refers to the master unit.
<unit_id> - Enter the unit ID used here.
980