D-Link xStack DGS-3420 Series Reference Manual page 674

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
given a name that can be up to 32 characters.
<vlanid 2-4094> - Specify the VLAN ID of the multicast VLAN to be created. The range is from 2 to
4094.
remap_priority - (Optional) Specify the remap priority here.
<value 0-7> - Specify the remap priority (0 to 7) to be associated with the data traffic to be
forwarded on the multicast VLAN.
none - If none is specified, the packet's original priority will be used. The default setting is none.
replace_priority - (Optional) Specify that the packet's priority will be changed by the switch, based
on the remap priority. This flag will only take effect when the remap priority is set.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create an MLD snooping multicast VLAN with the VLAN name mv1 and the VID 2:
DGS-3420-28SC:admin#create mld_snooping multicast_vlan mv1 2
Command: create mld_snooping multicast_vlan mv1 2
Success.
DGS-3420-28SC:admin#
59-2 config mld_snooping multicast_vlan
Description
This command is used to configure MLD snooping multicast VLAN parameters. The member port list
and source port list cannot overlap. However, the member port of one multicast VLAN can overlap with
another multicast VLAN. The multicast VLAN must be created first using the create mld_snooping
multicast_vlan command before the multicast VLAN can be configured.
Format
config mld_snooping multicast_vlan <vlan_name 32> {[add | delete] [member_port <portlist> |
[source_port <portlist> | untag_source_port <portlist>] | tag_member_port <portlist>] | state
[enable | disable] | replace_source_ipv6 [<ipv6addr> | none] | remap_priority [<value 0-7> |
none] {replace_priority}}(1)
Parameters
<vlan_name 32> - Specify the name of the multicast VLAN to be configured. Each multicast VLAN is
given a name that can be up to 32 characters.
add - Specify to add a port.
delete - Specify to delete a port.
member_port - Specify member port of the multicast VLAN. The specified range of ports will
become untagged members of the multicast VLAN.
<portlist> - Specify a range of ports to be configured.
669