D-Link xStack DGS-3420 Series Reference Manual page 144

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
<value 0-7> - Enter the 802.1p priority tag used here.
ethernet_type - (Optional) Specifies the Ethernet type.
<hex 0x0-0xffff> - Enter the Ethernet type mask used here.
ip - Specifies an IP egress ACL rule.
vlan - (Optional) Specifies the VLAN name.
<vlan_name 32> - Enter the VLAN name used for this configuration here. This name can be
up to 32 characters long.
vlanid - Specifies a VLAN ID.
<vlanid 1-4094> - Enter the VLAN ID used for this congfiguration here. This value must be
between 1 and 4094.
mask - (Optional) Specifies the mask used.
<hex 0x0-x0fff> - Enter the mask value used here.
source_ip - (Optional) Specifies an IP source address.
<ipaddr> - Enter the source IP address used here.
mask - Specifies the source IP address used here.
<netmask> - Enter the source network mask here.
destination_ip - (Optional) Specifies an IP destination address.
<ipaddr> - Enter the destination IP address used here.
mask - Specifies the destination IP address used here.
<netmask> - Enter the destination network mask here.
dscp - (Optional) Specifies the value of DSCP. The DSCP value ranges from 0 to 63.
<value 0-63> - Enter the DSCP value used here. This value must be between 0 and 63.
icmp - (Optional) Specifies that the following parameters configured will apply to the ICMP
configuration.
type - Specifies that the rule will apply to the ICMP type traffic value.
<value 0-255> - Enter the ICMP traffic type value here. This value must be between 0 and
255.
code - Specifies that the rule will apply to the ICMP code traffic value.
<value 0-255> - Enter the ICMP code traffic value here. This value must be between 0 and
255.
igmp - (Optional) Specifies that the following parameters configured will apply to the IGMP
configuration.
type - Specifies that the rule will apply to the IGMP type traffic value.
<value 0-255> - Enter the IGMP type traffic value here. This value must be between 0 and
255.
tcp - (Optional) Specifies that the following parameters configured will apply to the TCP
configuration.
src_port - Specifies that the rule will apply to a range of TCP source ports.
<value 0-65535> - Enter the source port value here. This value must be between 0 and
65535.
mask - Specifies the TCP source port mask here.
<hex 0x0-0xffff> - Enter the TCP source port mask value here.
dst_port - Specifies that the rule will apply to a range of TCP destination ports.
<value 0-65535> - Enter the destination port value here. This value must be between 0 and
65535.
mask - Specifies the TCP destination port mask here.
<hex 0x0-0xffff> - Enter the TCP destination port mask value here.
flag - (Optional) Specifies the TCP flag fields.
all - Specifies that the TCP flag field will be set to 'all'.
urg - Specifies that the TCP flag field will be set to 'urg'.
ack - Specifies that the TCP flag field will be set to 'ack'.
psh - Specifies that the TCP flag field will be set to 'psh'.
rst - Specifies that the TCP flag field will be set to 'rst'.
syn - Specifies that the TCP flag field will be set to 'syn'.
fin - Specifies that the TCP flag field will be set to 'fin'.
139