D-Link xStack DGS-3420 Series Reference Manual page 179
Layer 2 managed stackable gigabit switch cli
Hide thumbs
Also See for xStack DGS-3420 Series:
- Reference manual (499 pages) ,
- Hardware installation manual (53 pages) ,
- How to set up (2 pages)
Table of Contents
Advertisement
xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
11-7
config out_band_ipif
Description
This command is used to configure the out of band management port settings.
Format
config out_band_ipif {ipaddress <network_address> | state [enable | disable] | gateway
<ipaddr>} (1)
Parameters
ipaddress - Specify the IP address of the interface. The parameter must include the mask.
<network_address> - Specify the IP address of the interface. The parameter must include the
mask.
state – Specify the interface status.
enable - Specify to enable the interface.
disable - Specify to disable the interface.
gateway - Specify the gateway IP address of the out-of-band management network.
<ipaddr> - Specify the gateway IP address.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable the out-of-band management state:
DGS-3420-28SC:admin#config out_band_ipif state disable
Command: config out_band_ipif state disable
Success.
DGS-3420-28SC:admin#
11-8
show out_band_ipif
Description
This command is used to display the current configurations of special out-of-band management
interfaces.
Format
show out_band_ipif
174
Advertisement
Table of Contents
