D-Link xStack DGS-3420 Series Reference Manual page 594

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
<portlist> - (Optional) Specify the ports to be displayed.
Note: When a port list is not specified, information for all ports will be displayed.
Restrictions
None.
Example
To display LLDP TLV option port 1:
DGS-3420-28SC:admin#show lldp ports 1
Command: show lldp ports 1
Port ID
--------------------------------------------------------------
Admin Status
Notification Status
Advertised TLVs Option
Port Description
System Name
System Description
System Capabilities
Enabled Management Address
(None)
Port VLAN ID
Enabled Port_and_Protocol_VLAN_ID
(None)
Enabled VLAN Name
(None)
Enabled Protocol Identity
(None)
MAC/PHY Configuration/Status
Link Aggregation
Maximum Frame Size
DGS-3420-28SC:admin#
51-9 config lldp_med fast_start repeat_count
Description
This command is used to configure the fast start repeat count. When an LLDP-MED Capabilities TLV
is detected for an MSAP identifier not associated with an existing LLDP remote system MIB, the
: 1
: TX_and_RX
: Disabled
:
589
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled