D-Link DGS-3000 Series Reference Manual page 326

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To recover IMPB checking for ports 6 to 7:
DGS-3000-26TC:admin#config address_binding recover_learning ports 6-7
Command: config address_binding recover_learning ports 6-7
Success.
DGS-3000-26TC:admin#
34-26 debug address_binding
Description
This command is used to start the IMPB debug when the IMPB module receives an ARP/IP packet
or a DHCP packet.
Format
debug address_binding [event | dhcp | all] state [enable | disable]
Parameters
event - Prints out the debug messages when IMPB module receives ARP/IP packets.
dhcp - Prints out the debug messages when the IMPB module receives the DHCP packets.
all - Prints out all debug messages.
state - Specifies the IMPB debug state to be enabled or disabled.
enable - Specifies to enable the state.
disable - Specifies to disable the state.
Restrictions
Only Administrator users can issue this command.
Example
To print out all debug IMPB messages:
DGS-3000-26TC:admin#debug address_binding all state enable
Command: debug address_binding all state enable
Success.
DGS-3000-26TC:admin#
322