Delete Ipif; Enable Ipif - D-Link DGS-3000 Series Reference Manual

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
Example
To configure an interface's IPv4 network address:
DGS-3000-26TC:admin#config ipif System ipaddress 192.168.69.123/24 vlan default
Command: config ipif System ipaddress 192.168.69.123/24 vlan default
Success.
DGS-3000-26TC:admin#

10-15 delete ipif

Description
This command is used to delete an IP interface.
Format
delete ipif [<ipif_name 12> {ipv6address <ipv6networkaddr>} | all]
Parameters
ipif - Specifies the name of the IP interface.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
ipv6address – (Optional) Specifies the IPv6 network address. The address should specify a host
address and length of network prefix. There can be multiple IPv6 addresses defined on an
interface.
<ipv6networkaddr> - Enter the IPv6 address used here.
all – Specifies that all the IP interfaces will be used.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To delete an IP interface:
DGS-3000-26TC:admin#delete ipif newone
Command: delete ipif newone
Success.
DGS-3000-26TC:admin#

10-16 enable ipif

Description
This commands is used to enable the IP interface.
124