D-Link DGS-3000 Series Reference Manual page 431

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
Format
config mld_snooping [vlan_name <vlan_name 32> | vlanid <vlanid_list> | all ] {state [enable
| disable] | fast_done [enable | disable] | report_suppression [enable | disable] |
proxy_reporting {state [enable | disable] | source_ip <ipv6addr>}(1)}(1)
Parameters
vlan_name - Specifies the name of the VLAN for which MLD snooping is to be configured.
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters
long.
vlanid - Specifies the ID of the VLAN for which MLD snooping is to be configured.
<vlanid_list> - Enter the VLAN ID list here.
all - Specifies all VLANs for which MLD snooping is to be configured.
state - Specifies to enable or disable MLD snooping for the chosen VLAN.
enable - Specifies to enable MLD snooping for the chosen VLAN.
disable - Specifies to disable MLD snooping for the chosen VLAN.
fast_done - Specifies to enable or disable MLD snooping fast_leave function.
enable - Specifies to enable MLD snooping fast_leave function. If enable, the membership is
immediately removed when the system receive the MLD leave message.
disable - Specifies to disable MLD snooping fast_leave function.
report_suppression - Specifies wheather to send the first MLD report from all hosts for a group
to all the multicast routers.
enable - When MLD report suppression is enabled, the Switch sends the first MLD report from
all hosts for a group to all the multicast routers. The Switch does not send the remaining
MLD reports for the group to the multicast routers. If the multicast router query includes
requests only for MLDv1 reports, the Switch forwards only the first MLDv1 report from all
hosts for a group to all the multicast routers. If the multicast router query also includes
requests for MLDv2 reports, the Switch forwards all MLDv2 reports for a group to the
multicast devices. This is the default.
disable - Specifies not to send any MLD report from all hosts for a group to all the multicast
routers.
proxy reporting - Specifies MLD proxy reporting.
state - Specifies to enable or disable the proxy reporting.
enable - Enables the proxy reporting.
disable - Disables the proxy reporting.
source_ip - Specifies the source IP of proxy reporting integrated report. Default value is zero
IP.
<ipv6addr> - Enter the Ipv6 address.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure MLD snooping:
DGS-3000-26TC:admin#config mld_snooping vlan_name default state enable
Command: config mld_snooping vlan_name default state enable
Success.
DGS-3000-26TC:admin#
427