D-Link DGS-3000 Series Reference Manual page 127

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
Format
config ipif <ipif_name 12> [{ipaddress <network_address> | vlan <vlan_name 32> | state
[enable | disable]} | bootp | dhcp | ipv6 [ipv6address <ipv6networkaddr> | state [enable |
disable]] | ipv4 state [enable | disable] | dhcp_option12 [hostname <hostname63> |
clear_hostname | state [enable | disable]]]
Parameters
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12 characters
long.
ipaddress - (Optional) Configures a network on an ipif. The address should specify a host
address and length of network mask. Since an ipif can have only one IPv4 address, the new
configured address will overwrite the original one.
<network_address> - Enter the network address used here.
vlan - (Optional) Specifies the name of the VLAN here.
<vlan_name 32> - Enter the VLAN name used here. This name can be up to 32 characters
long.
state - (Optional) Specifies the state of the interface.
enable - Enables the state of the interface.
disable - Disables the state of the interface.
bootp - Uses BOOTP to obtain the IPv4 address.
dhcp - Uses DHCP to obtain the IPv4 address.
ipv6 - Specifies that the IPv6 configuration will be done.
ipv6address - Specifies the IPv6 network address. The address should specify a host
address and length of network prefix. There can be multiple IPv6 addresses defined on an
interface. Thus, as a new address is defined, it is added on this ipif.
<ipv6networkaddr> - Enter the IPv6 address used here.
state - Specifies that the IPv6 interface state will be set to enabled or disabled.
enable - Specifies that the IPv6 interface sate will be enabled.
disable - Specifies that the IPv6 interface sate will be disabled.
ipv4 - Specifies that the IPv4 configuration will be done.
state - Specifies that the IPv4 interface state will be set to enabled or disabled.
enable - Specifies that the IPv4 interface sate will be enabled.
disable - Specifies that the IPv4 interface sate will be disabled.
dhcp_option12 - Specifies the DHCP option 12.
hostname - Specifies the host name to be inserted in the DHCPDISCOVER and
DHCPREQUEST message.
<hostname 63> - Enter a name starting with a letter, end with a letter or digit, and have
only letters, digits, and hyphen as interior characters; the maximal length is 63.
clear_hostname - Clears the host name setting. If host name is empty, system name will be
used to encode option 12. The length of system is more than 63, the superfluous chars will
be truncated. If system name is also empty, then product model name will be used to
encode option 12.
state - Enables or disables insertion of option 12 in the DHCPDISCOVER and
DHCPREQUEST message. The state is disable by default.
enable - Enables insertion of option 12 in the DHCPDISCOVER and DHCPREQUEST
message.
disable - Disables insertion of option 12 in the DHCPDISCOVER and DHCPREQUEST
message.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
123