D-Link DGS-3000 Series Reference Manual page 681

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
DGS-3000-26TC:admin#config traffic control log state enable
Command: config traffic control log state enable
Success.
DGS-3000-26TC:admin#
78-5 config traffic control auto_recover_time
Description
This command is used to configure the traffic auto-recovery time that is allowed for a port to
recover from the shutdown forever status. When the auto-recovery option is disabled on a port, the
port will remain in the shutdown mode. The only way to restore the port to the forwarding state is
by entering the config ports [ <portlist> | all ] state enable command manually.
Format
config traffic control auto_recover_time [<min 0> | <min 1-65535>]
Parameters
<min 0> - Specifies that the auto-recovery option will be disabled. This is the default value.
<min 1-65535> - Enter the auto-recovery from shutdown time value here. This value must be
between 1 and 65535.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the auto-recovery time to 5 minutes:
DGS-3000-26TC:admin#config traffic control auto_recover_time 5
Command: config traffic control auto_recover_time 5
Success.
DGS-3000-26TC:admin#
677