D-Link DGS-3000 Series Reference Manual page 131

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
10-19 enable ipif_ipv6_link_local_auto
Description
This command is used to enable the auto configuration of link local address when there are no
IPv6 addresses explicitly configured. When an IPv6 address is explicitly configured, the link local
address will be automatically configured, and the IPv6 processing will be started. When there is no
IPv6 address explicitly configured, by default, link local address is not configured and the IPv6
processing will be disabled. By enable this automatic configuration, the link local address will be
automatically configured and IPv6 processing will be started.
Format
enable ipif_ipv6_link_local_auto [<ipif_name 12> | all]
Parameters
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12 characters
long.
all - Specifies that all the IP interfaces will be used.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the IP interface for IPv6 link local automatic:
DGS-3000-26TC:admin#enable ipif_ipv6_link_local_auto newone
Command: enable ipif_ipv6_link_local_auto newone
Success.
DGS-3000-26TC:admin#
10-20 disable ipif_ipv6_link_local_auto
Description
This command is used to disable the auto configuration of link local address when no IPv6 address
are configured.
Format
disable ipif_ipv6_link_local_auto [<ipif_name 12> | all]
Parameters
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12 characters
long.
all - Specifies that all the IP interfaces will be used.
127