D-Link DGS-3000 Series Reference Manual page 433

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
version - (Optional) Specifies the version of MLD packet that will be sent by the Switch.
<value 1-2> - Enter the version number value here. This value must be between 1 and 2.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the MLD snooping querier:
DGS-3000-26TC:admin#config mld_snooping querier vlan_name default
query_interval 125 state enable
Command: config mld_snooping querier vlan_name default query_interval 125 state
enable
Success.
DGS-3000-26TC:admin#
47-3 config mld_snooping router_ports
Description
This command is used to designate a range of ports as being connected to multicast-enabled
routers. This will ensure that all packets with such a router as its destination will reach the
multicast-enabled router, regardless of protocol, etc.
Format
config mld_snooping mrouter_ports [vlan <vlan_name 32> | vlanid <vlanid_list>] [add |
delete] <portlist>
Parameters
vlan - Specifies the name of the VLAN on which the router port resides.
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters
long.
vlanid - Specifies the ID of the VLAN on which the router port resides.
<vlanid_list> - Enter the VLAN ID list here.
add - Specifies to add the router ports.
delete - Specifies to delete the router ports.
<portlist> - Specifies a range of ports to be configured.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To set up static router ports:
429