D-Link DGS-3000 Series Reference Manual page 8

Layer 2 managed gigabit switch

Hide thumbs Also See for DGS-3000 Series:

Table of Contents

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide

DGS-3000-26TC:admin#config account

Command: config account

Next possible completions:

DGS-3000-26TC:admin#config account

In the above example, the command config account was entered without the required parameter

<username>, the CLI returned the Next possible completions: <username> prompt. The up

arrow cursor control key was pressed to re-enter the previous command (config account) at the

command prompt. Now the appropriate username can be entered and the config account

command re-executed.

All commands in the CLI function in this way. In addition, the syntax of the help prompts are the

same as presented in this manual − angle brackets < > indicate a numerical value or character

string, braces { } indicate optional parameters or a choice of parameters, and brackets [ ] indicate

required parameters.

If a command is entered that is unrecognized by the CLI, the top-level commands will be displayed

under the Available commands: prompt.

DGS-3000-26TC:admin#the

Available commands:

DGS-3000-26TC:admin#

The top-level commands consist of commands such as show or config. Most of these commands

require one or more parameters to narrow the top-level command. This is equivalent to show what?

or config what? Where the what? is the next parameter.

For example, entering the show command with no additional parameters, the CLI will then display

all of the possible next parameters.