Chapter 71 Syslog And Trap Source-Interface Command List - D-Link DGS-3000 Series Reference Manual

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
Chapter 71 Syslog and Trap Source-
config syslog source_ipif [<ipif_name 12> {<ipaddr> | <ipv6addr> } | none]
show syslog source_ipif
config trap source_ipif [<ipif_name 12> {<ipaddr> | <ipv6addr> } | none]
show trap source_ipif
71-1 config syslog source_ipif
Description
This command is used to configure syslog source IP interface.
Format
config syslog source_ipif [<ipif_name 12> {<ipaddr> | <ipv6addr> } | none]
Parameters
<ipif_name 12> - Enter the IP interface name. If only specify this parameter, the least IPv4
address and the smallest IPv6 address of ipif_name will be used as source IP addresses. This
name can be up to 12 characters long.
<ipaddr> - (Optional) Enter the IP address used for the configuration here.
<ipv6addr> - (Optional) Enter the IPv6 address used for the configuration here.
none - Specifies to clear the configured source IP interface.
Restrictions
Only Administrators and Operators can issue this command.
Example
Configure syslog source IP interface:
DGS-3000-26TC:admin#config syslog source_ipif ipif3 14.0.0.5
Command: config syslog source_ipif ipif3 14.0.0.5
Success
DGS-3000-26TC:admin#
To clear the configured source IP interface for syslog:
interface Command List
635