D-Link DGS-3000 Series Reference Manual page 202

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the DHCP relay hops and time parameters:
DGS-3000-26TC:admin#config dhcp_relay hops 4 time 2
Command: config dhcp_relay hops 4 time 2
Success.
DGS-3000-26TC:admin#
20-2 config dhcp_relay add
Description
This command is used to add an IP destination address of the DHCP server for relay of
DHCP/BOOTP packets.
Format
config dhcp_relay add ipif <ipif_name 12> <ipaddr>
Parameters
ipif_name - The name of the IP interface which contains the IP address below.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
<ipaddr> - The DHCP/BOOTP server IP address.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To add a DHCP/BOOTP server to the relay table:
DGS-3000-26TC:admin#config dhcp_relay add ipif System 10.43.21.12
Command: config dhcp_relay add ipif System 10.43.21.12
Success.
DGS-3000-26TC:admin#
20-3 config dhcp_relay add vlanid
Description
This command is used to add an IP address as a destination to forward (relay) DHCP/BOOTP
packets. If there is an IP interface in the VLAN and it has configured a DHCP server at the
198