Chapter 59 Pppoe Circuit Id Insertions Command List - D-Link DGS-3000 Series Reference Manual

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
Chapter 59 PPPoE Circuit ID Insertions
config pppoe circuit_id_insertion state [enable | disable]
config pppoe circuit_id_insertion ports <portlist> {state [enable | disable] | circuit_id [mac | ip |
udf <string 32>]}(1)
show pppoe circuit_id_insertion
show pppoe circuit_id_insertion ports {<portlist>}
59-1 config pppoe circuit_id_insertion state
Description
This command is used to enable or disable PPPoE circuit ID insertion function. When both port
and global state are enabled, the system will insert the circuit ID tag to the received PPPoE
discover and request packet if the tag is absent, and remove the circuit ID tag from the received
PPPoE offer and session confirmation packet. The insert circuit ID contains the following
information: Client MAC address, Device ID and Port number. By default, Switch IP address is
used as the device ID to encode the circuit ID option.
Format
config pppoe circuit_id_insertion state [enable | disable]
Parameters
enable - Specifies to enable the PPPoE circuit ID insertion on the Switch.
disable - Specifies to disable the PPPoE circuit ID insertion on the Switch. This is the default.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the PPPoE circuit insertion state:
DGS-3000-26TC:admin#config pppoe circuit_id_insertion state enable
Command: config pppoe circuit_id_insertion state enable
Success.
DGS-3000-26TC:admin#
Command List
533