D-Link DGS-3000 Series Reference Manual page 528

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
DGS-3000-26TC:admin#show port_security
Command: show port_security
Port Security Trap/Log
System Maximum Address
VLAN Configuration (Only VLANs with limitation are displayed)
VID VLAN Name
---- --------------------------------
1 default
DGS-3000-26TC:admin#
57-8 enable port_security trap_log
Description
This command is used to enable port security traps/logs. When this command is enabled, if there's
a new MAC that violates the pre-defined port security configuration, a trap will be sent out with the
MAC and port information and the relevant information will be logged.
Format
enable port_security trap_log
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable a port security trap:
DGS-3000-26TC:admin#enable port_security trap_log
Command: enable port_security trap_log
Success.
DGS-3000-26TC:admin#
57-9 disable port_security trap_log
Description
This command is used to disable a port security trap/log. If the port security trap is disabled, no
trap will be sent out for MAC violations, and no log will be recorded.
: Disabled
: 256
Max. Learning Addr.
------------------
64
524