D-Link DGS-3000 Series Reference Manual page 73

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
Parameters
<string 15> - (Optional) The built-in or user-defined server group name. This value can be up to
15 characters long.
Restrictions
Only Administrators can issue this command.
Example
To display all authentication server groups:
DGS-3000-26TC:admin#show authen server_group
Command: show authen server_group
Group Name IP Address
--------------- ---------------
mix_1 10.1.1.222
10.1.1.223
radius 10.1.1.224
tacacs 10.1.1.225
tacacs+ 10.1.1.226
xtacacs 10.1.1.227
Total Entries : 5
DGS-3000-26TC:admin#
5-20 create authen server_host
Description
This command is used to create an authentication server host. When an authentication server host
is created, IP address and protocol are the index. That means over 1 authentication protocol
services can be run on the same physical host. The maximum supported number of server hosts is
16.
Format
create authen server_host [<ipaddr> | ipv6 <ipv6addr>] protocol [tacacs | xtacacs | tacacs+ |
radius] {port <int 1-65535> | [key [<key_string 254> | none]] | timeout <int 1-255> | retransmit
<int 1-20>}
Parameters
<ipaddr> - Enter the server host IP address.
ipv6 - Specifies the server host IPv6 address.
<ipv6addr> - Enter the server host IPv6 address.
protocol - Specifies the host's authentication protocol.
tacacs - Server host's authentication protocol.
xtacacs - Server host's authentication protocol.
Protocol
--------
TACACS+
TACACS
RADIUS
TACACS
TACACS+
XTACACS
69