Show Vlan - D-Link DGS-3000 Series Reference Manual

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
port list range are separated by a dash.
all - Specifies all ports for ingress checking.
gvrp_state - (Optional) Enables or disables the GVRP for the ports specified in the port list.
enable - Specifies that GVRP for the specified ports will be enabled.
disable - Specifies that GVRP for the specified ports will be disabled.
ingress_checking - (Optional) Enables or disables ingress checking for the specified portlist.
enable - Specifies that ingress checking will be enabled for the specified portlist.
disable - Specifies that ingress checking will be disabled for the specified portlist.
acceptable_frame - (Optional) The type of frame will be accepted by the port. There are two
types:
tagged_only - Only tagged packets can be accepted by this port.
admit_all - All packets can be accepted.
pvid - (Optional) Specifies the PVID of the ports.
<vlanid 1-4094> - Enter the VLAN ID here. The VLAN ID value must be between 1 and 4094.
Restrictions
Only Administrators and Operators can issue this command.
Example
To sets the ingress checking status, the sending and receiving GVRP information:
DGS-3000-26TC:admin#config port_vlan 1-5 gvrp_state enable ingress_checking
enabl
e acceptable_frame tagged_only pvid 2
Command: config port_vlan 1-5 gvrp_state enable ingress_checking enable acceptab
le_frame tagged_only pvid 2
Success.
DGS-3000-26TC:admin#
3-8

show vlan

Description
This command is used to display the vlan information including of parameters setting and
operational value.
Format
show vlan {<vlan_name 32>}
Parameters
<vlan_name 32> - (Optional) Enter the VLAN name to be displayed. The VLAN name can be up
to 32 characters long.
Restrictions
None.
27