Chapter 1 Mac Address Table Management Commands; Display Mac-Address - H3C S9500 Series Command Manual

Command Manual – MAC Address Table Management
H3C S9500 Series Routing Switches
Chapter 1 MAC Address Table Management
Note:
For details of the commands mac-address static vsi and display mac-address vsi,
refer to the MPLS-VPLS Commands in the MPLS VPN Volume.
1.1 MAC Address Table Management Commands

1.1.1 display mac-address

Syntax
display mac-address [ mac-addr [ vlan vlan-id ] | [ static | dynamic ] [ interface
interface-type interface-number ] [ vlan vlan-id ] [ count ] ]
View
Any view
Parameters
mac-addr: Specifies a MAC address.
vlan-id: Specifies a VLAN ID.
static: Specifies static MAC address entries. Once being saved, the static entries can
survive reboot and unless being removed manually, will never age out.
dynamic: Specifies dynamic MAC address entries. Dynamic entries will age out.
interface-type interface-number: Interface type and interface number.
count: Specifies to display the total number of MAC addresses in the MAC address
table.
Description
Use the display mac-address command to display MAC address table entries.
When managing the Layer-2 addresses of the switch, you can perform this command
to display Layer-2 address entries, whether they are dynamic or static, which ports they
belong to, which VLANs they belong to, and whether they have been aged out.
Chapter 1 MAC Address Table Management
Commands
1-1
Commands