Call Waiting Parameters; Call Forwarding Parameters - AudioCodes Mediant 2000 User Manual

Parameter
Web: Caller ID Transport Type
EMS: Transport Type
[CallerIDTransportType]

Call Waiting Parameters

A.11.5.2
The call waiting parameters are described in the table below.
Parameter
Web/EMS: Enable Call
Waiting
[EnableCallWaiting]
EMS: Send 180 For Call
Waiting
[Send180ForCallWaiting]

Call Forwarding Parameters

A.11.5.3
The call forwarding parameters are described in the table below.
Parameter
Web: Enable Call
Forward
[EnableForward]
SIP User's Manual
the P-Asserted-Identity header in 180/200 OK responses,
by setting the parameter AssertedIDMode to 1.

This parameter is applicable to ISDN, CAS interfaces.
Determines the device's behavior for Caller ID detection.

[0] Disable = The caller ID signal is not detected - DTMF
digits remain in the voice stream.

[1] Relay = (Currently not applicable.)

[3] Mute = The caller ID signal is detected from the
Tel/PSTN side and then erased from the voice stream
(default).
Note: Caller ID detection is applicable only to FXO interfaces.
Table A-41: Call Waiting Parameters
Determines whether Call Waiting is enabled.

[0] Disable = Disable the Call Waiting service.

[1] Enable = Enable the Call Waiting service (default).
If enabled, when the device initiates a Tel-to-IP call to a destination that
is busy, it plays a Call Waiting Ringback tone to the caller.
Notes:

The device's Call Progress Tones (CPT) file must include a Call
Waiting Ringback tone.

The EnableHold parameter must be enabled on the called side.
Determines the SIP response code for indicating Call Waiting.

[0] = Use 182 Queued response to indicate call waiting (default).

[1] = Use 180 Ringing response to indicate call waiting.
Table A-42: Call Forwarding Parameters
Enables the Call Forwarding feature.

[0] Disable = Disable the Call Forward service.

[1] Enable = Enable Call Forward service(default).
The device doesn't initiate call forward, it can only respond to call forward
requests.
Note: To use this service, the devices at both ends must support this
option.
520
Description
Description
Description
Document #: LTRT-68814
Mediant 2000