Ipsec Parameters; A.4.6 Ipsec Parameters - AudioCodes Mediant 2000 User Manual

Parameter
[SSHServerPort]
Web: SSH Admin Key
[SSHAdminKey]
Web: Require Public Key
[SSHRequirePublicKey]
Web: Max Payload Size
[SSHMaxPayloadSize]
Web: Max Binary Packet Size
[SSHMaxBinaryPacketSize]
[SSHMaxSessions]
Web: Enable Last Login Message
[SSHEnableLastLoginMessage]
Web: Max Login Attempts
[SSHMaxLoginAttempts]
A.4.6

IPSec Parameters

The Internet Protocol security (IPSec) parameters are described in the table below.
Parameter
IPSec Parameters
Web: Enable IP Security
EMS: IPSec Enable
[EnableIPSec]
Web: IP Security Associations Table
EMS: IPSec SA Table
[IPSecSATable]
SIP User's Manual
Range is any valid port number. The default port is 22.
Defines the RSA public key for strong authentication for logging in
to the SSH interface (if enabled).
The value should be a base64-encoded string. The value can be
a maximum length of 511 characters.
For more information, refer to the Product Reference Manual.
Enables RSA public keys for SSH.

[0] = RSA public keys are optional if a value is configured for
the parameter SSHAdminKey (default).

[1] = RSA public keys are mandatory.
Note: To define the key size, use the TLSPkeySize parameter.
Defines the maximum uncompressed payload size (in bytes) for
SSH packets.
The valid value is 550 to 32768. The default is 32768.
Defines the maximum packet size (in bytes) for SSH packets.
The valid value is 582 to 35000. The default is 35000.
Defines the maximum number of simultaneous SSH sessions.
The valid range is 1 to 2. The default is 2 sessions.
Enables message display in SSH sessions of the time and date of
the last SSH login. The SSH login message displays the number
of unsuccessful login attempts since the last successful login.

[0] Disable

[1] Enable (default)
Note: The last SSH login information is cleared when the device
is reset.
Defines the maximum SSH login attempts allowed for entering an
incorrect password by an administrator before the SSH session is
rejected.
The valid range is 1 to 3. the default is 3.
Table A-24: IPSec Parameters
Enables IPSec on the device.

[0] Disable (default)

[1] Enable
Note: For this parameter to take effect, a device reset is required.
This parameter table defines the IPSec SA table. This table allows you to
442
Description
Description
Document #: LTRT-68814
Mediant 2000