AudioCodes Mediant 2000 User Manual page 93

SIP User's Manual
Notes:
Version 6.4
•
For more information and examples of network interfaces configuration,
see ''Network Configuration'' on page 97.
•
When adding more than one interface, ensure that you enable VLANs
using the 'VLAN Mode' (VlANMode) parameter.
•
When booting using BootP/DHCP protocols (see the Product Reference
Manual), an IP address is obtained from the server. This address is used
as the OAMP address for this session, overriding the IP address you
configured in the 'Multiple Interface Table page. The address specified in
this table takes effect only after you save the configuration to the device's
flash memory. This enables the device to use a temporary IP address for
initial management and configuration, while retaining the address
(defined in this table) for deployment.
•
You can define firewall rules (access list) to deny (block) or permit (allow)
packets received from a specific IP interface configured in this table.
These rules are configured using the AccessList parameter (see
''Configuring Firewall Settings'' on page 121).
•
You can view currently active configured IP interfaces in the 'IP Active
Interfaces page (see ''Viewing Active IP Interfaces'' on page 385).
•
You can also configure this table using the ini file table parameter
InterfaceTable (see ''Networking Parameters'' on page 411).
•
For configuring Web interface tables, see ''Working with Tables'' on page
36.
93
10. Network
November 2011