AudioCodes Mediant 2000 User Manual page 502

Parameter
[RTCPActivationMode]
RTP Control Protocol Extended Reports (RTCP XR) Parameters
(Note: For a detailed description of RTCP XR reports, refer to the Product Reference Manual.)
Web: Enable RTCP XR
EMS: RTCP XR Enable
[VQMonEnable]
Web: Minimum Gap Size
EMS: GMin
[VQMonGMin]
Web/EMS: Burst Threshold
[VQMonBurstHR]
Web/EMS: Delay Threshold
[VQMonDelayTHR]
Web: R-Value Delay Threshold
EMS: End of Call Rval Delay
Threshold
[VQMonEOCRValTHR]
Web: RTCP XR Packet Interval
EMS: Packet Interval
[RTCPInterval]
Web: Disable RTCP XR Interval
Randomization
EMS: Disable Interval Randomization
[DisableRTCPRandomize]
EMS: RTCP XR Collection Server
Transport Type
[RTCPXRESCTransportType]
SIP User's Manual
Disables RTCP traffic when there is no RTP traffic. This
feature is useful, for example, to stop RTCP traffic that is
typically sent when calls are put on hold (by an INVITE with
'a=inactive' in the SDP).

[0] Active Always = RTCP is active even during inactive
RTP periods, i.e., when the media is in 'recvonly' or
'inactive' mode. (default)

[1] Inactive Only If RTP Inactive = No RTCP is sent
when RTP is inactive.
Enables voice quality monitoring and RTCP Extended
Reports (RTCP XR), according to Internet-Draft draft-ietf-
sipping-rtcp-summary-13.

[0] Disable = Disable (default)

[1] Enable = Enables
Note: For this parameter to take effect, a device reset is
required.
Defines the voice quality monitoring - minimum gap size
(number of frames). The default is 16.
Defines the voice quality monitoring - excessive burst alert
threshold. if set to -1 (default), no alerts are issued.
Defines the voice quality monitoring - excessive delay alert
threshold. if set to -1 (default), no alerts are issued.
Defines the voice quality monitoring - end of call low quality
alert threshold. if set to -1 (default), no alerts are issued.
Defines the time interval (in msec) between adjacent RTCP
reports.
The interval range is 0 to 65,535. The default interval is
5,000.
Determines whether RTCP report intervals are randomized
or whether each report interval accords exactly to the
parameter RTCPInterval.

[0] Disable = Randomize (default)

[1] Enable = No Randomize
Determines the transport layer used for outgoing SIP
dialogs initiated by the device to the RTCP-XR Collection
Server.

[-1] Not Configured (default)

[0] UDP

[1] TCP

[2] TLS
Note: When set to 'Not Configured', the value of the
parameter SIPTransportType is used.
502
Mediant 2000
Description
Document #: LTRT-68814