Part Ii: Management Tools - AudioCodes Mediant 2000 User Manual

Management Tools
This part provides an overview of the various management tools that can be used to
configure the device and describes how to configure the management settings. The
following management tools can be used to configure the device:

Embedded HTTP/S-based Web server - see ''Web-based Management'' on page

Command Line Interface (CLI) - see ''CLI-Based Management'' on page

Configuration INI file - see ''INI File-Based Management'' on page

AudioCodes Element Management System - see ''EMS-Based Management'' on page
71

Simple Network Management Protocol (SNMP) browser software - see ''SNMP-Based
Management'' on page
Notes:
•
•
•
65
Some configuration settings can only be done using specific
management tools. For example, the ini file method provides
many parameters that are not supported in the Web interface.
The CLI is used only for debugging.
If you use AudioCodes BootP/TFTP utility to assign an IP
address to the device (see Using BootP/TFTP Server on page
21), you can also in the same process load a firmware file
(.cmp) and a configuration ini file (.ini file). For more
information on using the BootP/TFTP utility, refer to the
Product Reference Manual.
Part II
25
63
73