Sas Configuration; General Sas Configuration; Enabling The Sas Application - AudioCodes Mediant 2000 User Manual

19.2

SAS Configuration

SAS supports various configuration possibilities, depending on how the device is deployed
in the network and the network architecture requirements. This section provides step-by-
step procedures on configuring the SAS application, using the device's Web interface.
The SAS configuration includes the following:

General SAS configuration that is common to all SAS deployment types (see ''General
SAS Configuration'' on page 322)

SAS outbound mode (see ''Configuring SAS Outbound Mode'' on page 325)

SAS redundant mode (see ''Configuring SAS Redundant Mode'' on page 326)

Gateway and SAS applications deployed together (see ''Configuring Gateway
Application with SAS'' on page 326)

Optional, advanced SAS features (see ''Advanced SAS Configuration'' on page 330)

19.2.1 General SAS Configuration

This section describes the general configuration required for the SAS application. This
configuration is applicable to all SAS modes.

19.2.1.1 Enabling the SAS Application

Before you can configure SAS, you need to enable the SAS application on the device.
Once enabled, the device's Web interface provides the SAS pages for configuring SAS.
Note:

To enable the SAS application:
1. Open the Applications Enabling page (Configuration tab > VoIP menu >
Applications Enabling > Applications Enabling).
2. From the 'Enable SAS' drop-down list, select Enable.
3. Click Submit.
4. Save the changes to the flash memory with a device reset; after the device resets, the
SAS menu appears and you can now begin configuring the SAS application.
SIP User's Manual
The SAS application is available only if the device is installed with the SAS
Software Upgrade Key. If your device is not installed with the SAS feature,
contact your AudioCodes representative.
Figure 19-8: Enabling SAS Application
322
Mediant 2000
Document #: LTRT-68814