AudioCodes Mediant 2000 User Manual page 185

SIP User's Manual

To add Proxy servers:
1. Open the Proxy Sets Table page (Configuration tab > VoIP menu > Control
Network submenu > Proxy Sets Table).
2. From the 'Proxy Set ID' drop-down list, select an ID for the desired group.
3. Configure the Proxy parameters according to the following table.
4. Click Submit to apply your changes.
5. To save the changes to flash memory, see ''Saving Configuration'' on page 350.
Parameter
Web: Proxy Set ID
EMS: Index
[ProxySet_Index]
Version 6.4
Figure 14-1: Proxy Sets Table Page
Table 14-4: Proxy Sets Table Parameters
The Proxy Set identification number.
The valid range is 0 to 31. The Proxy Set ID 0 is used as the default
Proxy Set.
Note: Although not recommended, you can use both default Proxy Set
(ID 0) and IP Groups for call routing. For example, in the Trunk Group
Settings page (see ''Configuring Trunk Group Settings'' on page 238)
you can configure a Serving IP Group to where you want to route
specific Trunk Group channels, and all other device channels then use
the default Proxy Set. You can also use IP Groups in the Outbound IP
Routing Table (see ''Configuring the Outbound IP Routing Table'' on
page 256) to configure the default Proxy Set if the parameter
PreferRouteTable is set to 1.
To summarize, if the default Proxy Set is used, the INVITE message is
185
Description
14. Control Network
November 2011