Configuring Tel Profile - AudioCodes Mediant 2000 User Manual

16.3

Configuring Tel Profile

The Tel Profile Settings page allows you to define up to nine SIP profiles for Tel calls
(termed Tel Profiles). Each Tel Profile contains a set of parameters for configuring various
behaviors, for example, used coder, silence suppression support, and echo canceler. Once
configured, Tel Profiles can then be assigned to specific trunks (channels). For example,
specific channels can be assigned a Tel Profile that must use the G.711 coder. Thus,
implementing Tel Profiles provides high-level adaptation when connected to a variety of
equipment and protocols (at both Tel and IP sides), each of which may require different
system behavior.
The Tel Profiles are assigned to the device's channels in the Trunk Group Table (see
Configuring the Trunk Group Table on page 236)).
Note:

To configure Tel Profiles:
1. Open the Tel Profile Settings page (Configuration tab > VoIP menu > Coders And
Profiles submenu > Tel Profile Settings).
SIP User's Manual
You can also configure Tel Profiles using the ini file table parameter TelProfile
(see ''Configuration Parameters Reference'' on page 409).
Figure 16-3: Tel Profile Settings Page
202
Mediant 2000
Document #: LTRT-68814