AudioCodes Mediant 2000 User Manual page 219

SIP User's Manual
On the top of the page, a bar with Trunk number icons displays the status of each
trunk, according to the following color codes:
•
Grey: Disabled
•
Green: Active
•
Yellow: RAI alarm (also appears when you deactivate a Trunk by clicking the
Deactivate button)
•
Red: LOS/LOF alarm
•
Blue: AIS alarm
•
Orange: D-channel alarm (ISDN only)
2. Select the trunk that you want to configure by clicking the desired Trunk number icon.
The bar initially displays the first eight trunk number icons (i.e., trunks 1 through 8). To
scroll through the trunk number icons (i.e., view the next/last or previous/first group of
eight trunks), refer to the figure below:
Figure 18-3: Trunk Scroll Bar (Used Only as an Example)
Note:
After you have selected a trunk, the following is displayed:
•
The read-only 'Trunk ID' field displays the selected trunk number.
•
The read-only 'Trunk Configuration State' displays the state of the trunk ('Active'
or 'Inactive').
•
The displayed parameters pertain to the selected trunk only.
3. Click the Stop Trunk
out of service so that you can configure the currently grayed out (unavailable)
parameters. (Skip this step if you want to configure parameters that are available
when the trunk is active). The stopped trunk is indicated by the following:
•
The 'Trunk Configuration State' field displays 'Inactive'.
•
The Stop Trunk button is replaced by the Apply Trunk Settings
When all trunks are stopped, the Apply to All Trunks
•
All the parameters are available and can be modified.
4. Configure the trunk parameters as required.
5. Click the Apply Trunk Settings button to apply the changes to the selected trunk (or
click Apply to All Trunks to apply the changes to all trunks); the Stop Trunk button
replaces Apply Trunk Settings and the 'Trunk Configuration State' displays 'Active'.
Version 6.4
If the Trunk scroll bar displays all available trunks, the scroll bar buttons are
unavailable.
button (located at the bottom of the page) to take the trunk
219
18. GW and IP to IP
button.
button also appears.
November 2011