AudioCodes Mediant 2000 User Manual page 109

SIP User's Manual

To configure static IP routing:
1. Open the IP Routing Table page (Configuration tab > VoIP menu > Network
submenu > IP Routing Table).
2. In the Add a new table entry table, add a new static routing rule according to the
parameters described in the table below.
3. Click Add New Entry; the new routing rule is added to the IP routing table.
To delete a routing rule from the table, select the 'Delete Row' check box corresponding to
the required routing rule, and then click Delete Selected Entries.
Notes:
Parameter
Destination IP Address
[StaticRouteTable_Destination]
Prefix Length
[StaticRouteTable_PrefixLength]
The address of the host/network you want to reach is determined by an AND operation that is applied
to the fields 'Destination IP Address' and 'Destination Mask'. For example, to reach the network
10.8.x.x, enter 10.8.0.0 in the field 'Destination IP Address' and 255.255.0.0 in the field 'Destination
Mask'. As a result of the AND operation, the value of the last two octets in the field 'Destination IP
Address' is ignored.
To reach a specific host, enter its IP address in the field 'Destination IP Address' and
255.255.255.255 in the field 'Destination Mask'.
Version 6.4
Figure 10-4: IP Routing Table Page
•
You can delete only inactive routing rules.
•
You can also configure the IP Routing table using the ini file table
parameter StaticRouteTable.
Table 10-13: IP Routing Table Description
Specifies the IP address of the destination host/network.
Specifies the subnet mask of the destination host/network.
Description
109
10. Network
November 2011