AudioCodes Mediant 2000 User Manual page 551

SIP User's Manual
Parameter
Web: Digital Out-Of-Service
Behavior
[DigitalOOSBehavior]
Web: Default Cause Mapping From
ISDN to SIP
[DefaultCauseMapISDN2IP]
Release Cause Mapping from ISDN to SIP Table
Web: Release Cause Mapping
Table
EMS: ISDN to SIP Cause Mapping
[CauseMapISDN2SIP]
Release Cause Mapping from SIP to ISDN Table
Web: Release Cause Mapping
Table
EMS: SIP to ISDN Cause Mapping
[CauseMapSIP2ISDN]
Version 6.4
stop the trunk and then restart it for the update to take
effect.

To determine the method for setting Out-Of-Service state for
all trunks (i.e., per device), use the DigitalOOSBehavior
parameter.

The ID in the ini file parameter name represents the trunk
number, where 0 is the first trunk.
Determines the method for setting digital trunks to Out-Of-
Service state per device. For a description, see the
DigitalOOSBehaviorFor Trunk_ID parameter.
Note: To configure the method for setting Out-Of-Service state
per trunk, use the DigitalOOSBehaviorForTrunk_ID parameter.
Defines a single default ISDN release cause that is used (in
ISDN-to-IP calls) instead of all received release causes, except
when the following Q.931 cause values are received: Normal
Call Clearing (16), User Busy (17), No User Responding (18),
or No Answer from User (19).
The range is any valid Q.931 release cause (0 to 127). The
default value is 0 (i.e., not configured - static mapping is used).
This parameter table maps ISDN Q.850 Release Causes to SIP
responses.
The format of this parameter is as follows:
[CauseMapISDN2SIP]
FORMAT CauseMapISDN2SIP_Index =
CauseMapISDN2SIP_IsdnReleaseCause,
CauseMapISDN2SIP_SipResponse;
[\CauseMapISDN2SIP]
Where,

IsdnReleaseCause = Q.850 Release Cause

SipResponse = SIP Response
For example:
CauseMapISDN2SIP 0 = 50,480;
CauseMapISDN2SIP 0 = 6,406;
When a Release Cause is received (from the PSTN side), the
device searches this mapping table for a match. If the Q.850
Release Cause is found, the SIP response assigned to it is sent
to the IP side. If no match is found, the default static mapping is
used.
Notes:

This parameter can appear up to 12 times.

For configuring ini file table parameters, see ''Configuring ini
File Table Parameters'' on page 74.
This parameter table maps SIP responses to Q.850 Release
Causes. The format of this parameter is as follows:
[CauseMapSIP2ISDN]
FORMAT CauseMapSIP2ISDN_Index =
CauseMapSIP2ISDN_SipResponse,
CauseMapSIP2ISDN_IsdnReleaseCause;
551
A. Configuration Parameters Reference
Description
November 2011