Tone Parameters; Telephony Tone Parameters - AudioCodes Mediant 2000 User Manual

Parameter
A.11.9 Tone Parameters
This subsection describes the device's tone parameters.

Telephony Tone Parameters

A.11.9.1
The telephony tone parameters are described in the table below.
Parameter
[PlayHeldToneForIP2IP]
Web/EMS: Dial Tone Duration [sec]
[TimeForDialTone]
Web/EMS: Reorder Tone Duration
[sec]
[TimeForReorderTone]
Web: Cut Through Reorder Tone
Duration [sec]
[CutThroughTimeForReOrderTone]
SIP User's Manual

This parameter is applicable only to CAS protocols.

This parameter can also be configured per Tel Profile,
using the TelProfile parameter.
Table A-55: Tone Parameters
Enables playing a Held tone to an IP-to-IP leg instead of
putting it on hold.

[0] = Disabled. The device interworks the re-INVITE with
a=inactive from one SIP leg to another SIP leg. (default)

[1] = Enabled. The device plays a Held tone to the IP if it
receives a re-INVITE with a=inactive in the SDP from the
party initiating the call hold. The Held tone must be
configured in the CPT or PRT file.
Note: This parameter is applicable only to the IP-to-IP
application (enabled using the parameter
EnableIP2IPApplication).
Defines the duration (in seconds) that the dial tone is played
to an ISDN terminal.
This parameter is applicable for overlap dialing when
ISDNInCallsBehavior is set to 65536. The dial tone is played
if the ISDN Setup message doesn't include the called
number.
The valid range is 0 to 60. The default is 5.
Defines the duration (in seconds) that the CAS device plays a
Busy or Reorder Tone before releasing the line.
The valid range is 0 to 15. The default value is 10.
Notes:

The selection of Busy or Reorder tone is performed
according to the release cause received from IP.

This parameter is also applicable for ISDN when
PlayBusyTone2ISDN is set to 2.

This parameter can also be configured per Tel Profile,
using the TelProfile parameter).
Defines the duration (in seconds) of the Reorder tone played
to the PSTN side after the IP call party releases the call, for
the Cut-Through feature. After the tone stops playing, an
incoming call is immediately answered if the PSTN is
connected.
The valid values are 0 to 30. The default is 0 (i.e., no Reorder
tone is played).
564
Description
Description
Document #: LTRT-68814
Mediant 2000