Configuring Ip Security Proposal Table - AudioCodes Mediant 2000 User Manual

11.3

Configuring IP Security Proposal Table

The IP Security Proposals Table page is used to configure Internet Key Exchange (IKE)
with up to four proposal settings. Each proposal defines an encryption algorithm, an
authentication algorithm, and a Diffie-Hellman group identifier. The same set of proposals
applies to both Main mode and Quick mode.
Note:

To configure IP Security Proposals:
1. Open the 'IP Security Proposals Table page (Configuration tab > VoIP menu >
Security submenu > IPSec Proposal Table).
In the figure above, four proposals are defined.
2. Select an Index, click Edit, and then modify the proposal as required.
3. Click Apply.
4. To save the changes to flash memory, see ''Saving Configuration'' on page 350.
To delete a proposal, select the relevant Index number, and then click Delete.
Table 11-2: IP Security Proposals Table Configuration Parameters
Parameter Name
Encryption Algorithm
[IPsecProposalTable_EncryptionAlgorithm]
Authentication Algorithm
[IPsecProposalTable_AuthenticationAlgorithm]
SIP User's Manual
You can also configure the IP Security Proposals table using the ini file table
parameter IPsecProposalTable (see ''Security Parameters'' on page 435).
Figure 11-2: IP Security Proposals Table
Description
Determines the encryption (privacy) algorithm.

[0] NONE

[1] DES CBC

[2] 3DES CBC

[3] AES (default)
Determines the message authentication
(integrity) algorithm.

[0] NONE

[2] HMAC SHA1 96

[4] HMAC MD5 96 (default)
126
Mediant 2000
Document #: LTRT-68814